Flagpole Installation Guys

Home › Los Angeles, CA

Flagpole Installation Services in Los Angeles, CA

Flagpole Installation Guys installs in-ground, wall-mounted, and commercial flagpoles across Los Angeles, CA, from San Pedro to Sylmar in Los Angeles County. The city wants a building permit for any yard pole taller than 15 feet, and only about 36 percent of homes here are detached houses, so wall-mounted poles matter as much as yard poles. Contact us now for a free estimate.

How Much Does Flagpole Installation Cost in Los Angeles, CA?

Flagpole installation in Los Angeles costs anywhere from $520 to $2,100 on average for a residential in-ground pole of 20 to 25 feet with the pole included. What moves the price here is the building permit and footing drawing the city wants for any pole over 15 feet, a heavier wind-rated pole in the high wind parts of the Valley, hillside access, and clay or rock in the hole. Send us the address and pole height for a firm price.

Do You Install Flagpoles at Homes and Businesses in Los Angeles?

Yes, we install in-ground poles in yards and at businesses, schools, and churches, and wall-mounted poles on buildings. Nearly half of the city's homes, about 48 percent, sit in buildings of five or more units, so tell us the property type first.

Do I Need a Permit to Install a Flagpole in Los Angeles?

Yes, for most poles. The city building code exempts only flag poles that are not erected upon a building and are not more than 15 feet high (LAMC 91.106.2). The usual 20 to 25 foot yard pole needs a building permit from the Department of Building and Safety. Confirm with LADBS before you order.

How Tall Can a Flagpole Be at a House in Los Angeles?

The zoning code caps any building or structure at 33 feet in the R1, RS, and RE9 house zones and 36 feet in the larger-lot RE and RA zones (LAMC 12.21.1). A 25 foot pole fits under either. Hillside and coastal lots, specific plans, and historic districts follow other limits, so have LADBS confirm your address.

Can My HOA Stop Me From Putting Up a Flagpole in California?

No, not from flying the American flag. Civil Code 4705 bars an association from limiting display of the U.S. flag on your own unit or lot, including from a staff or pole. It gives no set pole height, so the pole itself usually still needs architectural approval. Get that in writing before we order.

Which Parts of Los Angeles Do You Cover?

We cover the whole city, from San Pedro and Wilmington to Sylmar and Sunland-Tujunga. That takes in the Valley (Encino, Northridge, Granada Hills, Chatsworth, Woodland Hills, Sherman Oaks, Van Nuys), the Westside (Brentwood, Pacific Palisades, Westwood, Venice, Westchester), Hollywood, Silver Lake, Boyle Heights, West Adams, and South Los Angeles.

Which Los Angeles ZIP Codes Do You Serve?

Every ZIP code in the city, including 90272, 90049, 90045, 90066, 90027, 90019, 90731, 91342, 91344, 91367 and 91406. Send us your ZIP and we'll confirm.

Do You Install Flagpoles in Cities Next to Los Angeles?

Yes, we also work in Santa Monica, Culver City, Beverly Hills, West Hollywood, Inglewood, Torrance, Burbank, Glendale, and Pasadena. Each is a separate city with its own permit rules, so the 15 foot rule and the height caps on this page apply only inside Los Angeles city limits. Tell us which city issues your permits.

How Soon Can You Install a Flagpole in Los Angeles?

Two waits set the date. DigAlert needs at least two working days to mark buried utilities, and a pole over 15 feet waits on its building permit, which is not on the LADBS express permit list. After the pour, the concrete usually cures 24 to 48 hours before we stand the pole.

What Do You Need From Me for a Flagpole Quote?

The address, the pole height you want, whether you already own the pole, and photos of the spot. Mention overhead wires, sprinklers, slopes, and any HOA or historic district.

Will I Need to Be Home During the Installation?

No, as long as we can reach the spot and you have approved the exact location. Moving a pole after the concrete sets means a new footing, so most people come out when we stake it.

How Long Does a Flagpole Installation Take?

Most residential poles take about one working day, split into two visits: one to dig and pour the footing, and one to stand the pole once the concrete has cured. Tall commercial poles that need a crane take longer.

Do I Need to Call 811 Before You Dig?

No, we place the request with DigAlert, the 811 center for Los Angeles County. State law requires at least two working days of notice, not counting the day of the request, and a ticket is valid for 28 days. The marks cover utility lines only, so show us sprinklers and yard lighting.

Can I Put a Flagpole in My Front Yard in Los Angeles?

Yes, though the exact spot needs checking. The city's zoning manual treats flying the American flag as an accessory use in any zone. Required yards must stay open except for a list of allowed items, and flagpoles are not on it, so ask the LADBS zoning counter how far back yours has to sit.

How Deep Does a Flagpole Have to Be Set in Los Angeles?

About 10 percent of the pole's height, or roughly 24 to 30 inches for a 20 to 25 foot pole. Frost is not a factor: the city's design table lists a 12 inch frost line. Soft fill, clay, and slopes push a footing deeper, and on a permitted pole the approved drawing sets the size.

How Close to Power Lines Can a Flagpole Go in Los Angeles?

Our rule is the pole's full height plus 10 feet from any overhead line. The legal floor is lower: California Penal Code 385 makes it a misdemeanor to put any tool, material, or structure within six feet of a high voltage line. Call LADWP, the city's electric utility, if you are unsure what a wire carries.

What Wind Rating Does a Flagpole Need in Los Angeles?

The city's design table lists a wind speed of 110 mph. That is an ultimate speed, and pole makers rate on an older scale where it works out to about 85 mph. Compare that with the pole's flagged rating, the one with a flag flying. A bigger flag lowers it.

Which Parts of Los Angeles Are High Wind Areas for a Flagpole?

The building department maps High Wind Velocity areas along the north and west edges of the San Fernando Valley, including land northeast of San Fernando Road and north of Roscoe Boulevard, north of Devonshire Street west of the San Diego Freeway, and west of Valley Circle Boulevard. A heavier pole and a smaller flag make sense there.

Can You Mount a Flagpole on a House, Condo, or Apartment Building?

Yes, we mount brackets and outrigger poles on wood, stucco, and masonry walls. The 15 foot permit exemption covers only poles not erected upon a building, so we check larger wall and roof poles with LADBS. Zoning lets a roof flagpole rise five feet above the height limit if it sits five feet in from the edge.

Can Renters Put Up a Flagpole in Los Angeles?

Yes, with the owner's written permission, which matters here because about 64 percent of households rent. Government Code 434.5 protects displaying a U.S. flag on private property by anyone who otherwise has the right, but it says nothing about digging a footing in a landlord's yard. A wall bracket is the easier ask.

Do I Need a Light on My Flagpole, and Are Spotlights Allowed?

No, only if the flag stays up after dark, since the Flag Code custom is sunrise to sunset unless the flag is lit. Spotlights are allowed, but LAMC 93.0117 bars an outdoor light that puts more than two footcandles or direct glare on a neighbor's windows or yard. A small solar light on top of the pole avoids the problem.

Can You Install a Flagpole I Already Bought?

Yes, send us the brand, height, and installation sheet. A pole over 15 feet still needs its permit whoever supplies it, so share the paperwork before the pole ships.

Can You Replace or Remove an Old Flagpole?

Yes, we take down the old pole, break out the footing, and set the new one. Tell us the height, whether it sits in a sleeve or straight in concrete, and how close it is to wires.

Can You Install a Flagpole on a Hillside Lot in Los Angeles?

Yes, we set the sleeve plumb whatever the grade does. Next to a slope steeper than 3 horizontal to 1 vertical, the building code sets footings back from the slope face, so lots in Bel Air, Beverly Crest, Brentwood, and Studio City need a closer look. Tell us if concrete has to be carried in.

Can You Install a Flagpole in Clay or Expansive Soil?

Yes, with a wider hole, a gravel bed, and concrete around the sleeve. Where expansive soil is present or untested, the building department wants exterior building footings at least 24 inches deep. Pole makers size footings for good soil, so on clay we go larger than the instruction sheet.

When Is the Best Time of Year to Install a Flagpole in Los Angeles?

Any month works, because the ground here does not freeze. About 92 percent of the year's rain falls between November and April, so a wet week can push a pour back. We also plan around Santa Ana winds, best known in autumn, since standing a tall pole in strong gusts is unsafe.

Do I Need Historic Review for a Flagpole in an HPOZ?

Yes, plan on it. City Planning says all exterior work in a Historic Preservation Overlay Zone, including landscaping, gets additional review. That covers districts such as Angelino Heights, Hancock Park, Windsor Square, Carthay Circle, Miracle Mile, and Jefferson Park. Ask the district's planner before we order a pole.

Can I Fly a Military or State Flag in a California HOA?

Yes, within a size limit. Civil Code 4710 says an association cannot prohibit noncommercial flags on your own unit or lot, but may prohibit ones larger than 15 square feet. A 3 by 5 foot flag is exactly 15 square feet, so that is the safe size for a service or state flag.

Can I Put a Flagpole in the Parkway Between the Sidewalk and the Curb?

No, not without city approval. That strip is normally public right-of-way, and the building code says projections into the public right-of-way require the approval of the Department of Public Works (LAMC 91.3201.3). We set poles on private property, behind the sidewalk.